Steve'sDigicams

AVspec · Jun 9, 2006, 8:43 PM

I did pick up the Aiptek MPVR from Worst Buy and took it to my daughters elementry school graduation and filmed some video and took some still shots but they did not turn out that good. The stills were a bit blurry even with I.S. turned on and the video was also not very sharp but I was rather far away from the source and did use digital zoom which may have hurt the video?

Looks like the SVP should be here very soon looking at DHL's website but not sure if they deliver on Sat.

Also the 2GB SD card arrived but I have not had a chance to test it out either.

fishycomics · Jun 10, 2006, 5:57 AM

1. indoor lighting was not bright

2 you were far away

3 you used digitl zoom

4 possably you had machro on by error

5 stabilizer will not effect video will improve it.

6 quality mode may have been set on low

these are just comments not saying you did anything wrong? some like it some do not.....

AVspec · Jun 10, 2006, 6:20 AM

fishycomics wrote:

Quote:

1. indoor lighting was not bright

2 you were far away

3 you used digitl zoom

4 possably you had machro on by error

5 stabilizer will not effect video will improve it.

6 quality mode may have been set on low

these are just comments not saying you did anything wrong? some like it some do not.....

1. correct

2. also correct

3. my bad

4. how do I check this setting?

5. good to know.

6. What is the best setting? I used VGA mode. not QVGA. Also does the MP setting effect the video or only the still pictures?

fishycomics · Jun 10, 2006, 9:56 AM

mp ??? my noodel stopped sorry?

5 machro looks like a spade and there is an switch on the outside by the lens should face down looks like a body

AVspec · Jun 10, 2006, 2:49 PM

Yes, switch has always been down. It should only be used in the other setting for extreme closeups... correct?

fishycomics · Jun 10, 2006, 2:54 PM

yes it should. sometimes these switchs get stuck in place oor between place that can cause a blurr.

AVspec · Jun 10, 2006, 7:18 PM

I will give the MPVR a few more tests tomorrow with the 2GB card and see what kind of results I get with no zoom and more daylight.

The DV-12T-2 has not arrived yet so no comparisons yet...

AVspec · Jun 13, 2006, 8:12 PM

Ok, I have had time to compare both Hybrids in movie mode.

The MPVR has a better picture as long as you dont move the camera. As soon as you start to pan around the picture blurs. The SVP is better as far as moving the camera around but the image has much more artifacts in it.

Is there away to not get bluring while moving the MPVR? I have tried both with I.S. on and off with not change.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Steve'sDigicams

Recent Camera Reviews

Most Active Forums

Most Popular Deals

Latest Feature Articles

Jun 9, 2006, 8:43 PM	#11
AVspec Junior Member Join Date: Jun 2006 Posts: 11	I did pick up the Aiptek MPVR from Worst Buy and took it to my daughters elementry school graduation and filmed some video and took some still shots but they did not turn out that good. The stills were a bit blurry even with I.S. turned on and the video was also not very sharp but I was rather far away from the source and did use digital zoom which may have hurt the video? Looks like the SVP should be here very soon looking at DHL's website but not sure if they deliver on Sat. Also the 2GB SD card arrived but I have not had a chance to test it out either.

Jun 10, 2006, 5:57 AM	#12
fishycomics Moderator Join Date: Jul 2005 Location: NYC NY Posts: 9,683	1. indoor lighting was not bright 2 you were far away 3 you used digitl zoom 4 possably you had machro on by error 5 stabilizer will not effect video will improve it. 6 quality mode may have been set on low these are just comments not saying you did anything wrong? some like it some do not.....

Jun 10, 2006, 9:56 AM	#14
fishycomics Moderator Join Date: Jul 2005 Location: NYC NY Posts: 9,683	mp ??? my noodel stopped sorry? 5 machro looks like a spade and there is an switch on the outside by the lens should face down looks like a body

Jun 10, 2006, 2:49 PM	#15
AVspec Junior Member Join Date: Jun 2006 Posts: 11	Yes, switch has always been down. It should only be used in the other setting for extreme closeups... correct?

Jun 10, 2006, 2:54 PM	#16
fishycomics Moderator Join Date: Jul 2005 Location: NYC NY Posts: 9,683	yes it should. sometimes these switchs get stuck in place oor between place that can cause a blurr.

Jun 10, 2006, 7:18 PM	#17
AVspec Junior Member Join Date: Jun 2006 Posts: 11	I will give the MPVR a few more tests tomorrow with the 2GB card and see what kind of results I get with no zoom and more daylight. The DV-12T-2 has not arrived yet so no comparisons yet...

Jun 13, 2006, 8:12 PM	#18
AVspec Junior Member Join Date: Jun 2006 Posts: 11	Ok, I have had time to compare both Hybrids in movie mode. The MPVR has a better picture as long as you dont move the camera. As soon as you start to pan around the picture blurs. The SVP is better as far as moving the camera around but the image has much more artifacts in it. Is there away to not get bluring while moving the MPVR? I have tried both with I.S. on and off with not change.