Go Back   Steve's Digicams Forums >

LinkBack Thread Tools Search this Thread
Old Apr 15, 2015, 2:29 AM   #1
Junior Member
Join Date: Apr 2015
Posts: 2
Default Epson Stylus Photo R320 End Sensor not working

It's an old printer, but it would be nice to fix it rather than skip it. I suspect it's not hard, given the right instructions.

It fell on the floor, and now when going through it's startup it runs OK until it whizzes to the left and goes clunk, rather than a graceful return, and gives a general error, which cannot be recovered from.

Reading around it may be that the end sensor cable may have become dislodged, but it's not obvious having taken the top off where that is - there's nothing obvious.

Does anyone have a service manual for this old printer, or any helpful guide (with pictures?) on how to progress?

Many thanks!
exbucks is offline   Reply With Quote
Sponsored Links
Old Apr 15, 2015, 9:46 AM   #2
Junior Member
Join Date: Apr 2015
Posts: 2

To follow up, in case anyone sees this, I tried squeezing the flat cables into the print head carriage, and I suspect that pushing the bottom one was the solution (arrowed in the attachment).

I took the silver top off (screws, including one under the top LCD, and clips pushed from inside), which was a lot of hassle, but I'm sure it could be done without doing so.
Attached Images
exbucks is offline   Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -5. The time now is 9:50 PM.